BUSINESS SERVICES>
Scheduled
Work
TRIPLE POINT are here to serve the
business community in Edinburgh and surrounding areas. Triple
Point provide repair and maintenance services on a scheduled
appointment basis - just contact us
to make an appointment and you can be sure that we'll do our
utmost to stick to it.
We cover : CENTRAL HEATING, PLUMBING
& DRAINAGE and POWER FLUSHING
CENTRAL
HEATING
| Triple Point can install and maintain a
wide variety of central heating systems including Gas,
Oil Fired and LPG. All work being performed has guaranteed
workmanship, at a time convenient for you. Our engineers
are CORGI registered and AGA Approved. |
|
 |
| TYPE OF SYSTEM |
TYPICAL WORK |
GAS
|
•
Boiler Breakdown - repair to all types of boiler.
• Installations - Boilers, radiators or full systems.
• Repairs - Radiators or pipework.
• Servicing
- Annual service of boilers and systems.
• Hot
water cylinders - installation & maintenance.
• Water tanks - installation and replacement.
• Certification - Landlords Gas Safety Certicates
• Carbon Monoxide detectors supplied ands fitted.
• Installation of gas cookers and fires.
•
Carbon Monoxide detectors supplied and fitted.
•
Power Flushing |
OIL FIRED
|
LPG
|
PLUMBING
& DRAINAGE SERVICES
Triplepoint provide you with guaranteed workmanship, at a time
convenient to you for repairs and installations throughout your
business, office or property:
| |
Kitchen plumbing repairs and installation.
Additional taps and water supply.
Bathroom plumbing repairs and installation.
Installation of new water services.
Advice on system replacement and upgrade.
Repair leaks or clear internal drains.
Sewer and external drain clearing and repairs.
Guttering replaced or repaired to insurance standards. |
POWER FLUSHING
Corrosion
within central heating systems accounts for 90% of all system/boiler
failures.
Power flushing is the most efficient and effective method of
cleansing a central heating system. The principle is to create
a powerful fresh water flow under controlled conditions to remove
debris from the system.
By connecting the power flushing unit to the heating circuit
in place of the system pump, boiler or radiator the circuit
can be thoroughly cleansed of limescale and corrosion debris.
Why Powerflush?
| Power Flushing is used to prevent: |
• Fuel wastage - Without treatment,
corrosion debris will accumulate in the boiler
causing
increasing limescale deposits, reduced heat transfer and
up to a third of a
fuel bill going to
complete waste. |
• Boiler noise - This increases in
frequency and intensity as deposits of sludge and
scale build up in an unprotected boiler. |
• Cold spots - The familiar cool
low central area of a radiator indicates a build-up of
black sludge sediment that restricts
flow and reduces heat. |
• Frequent venting - When the top
of a radiator is cold during operation, either air or
hydrogen is to blame. Hydrogen gas builds
up as a by-product of electrolytic
corrosion
and is flammable (due caution is required). |
• Pump seizure and failure - The
abrasive and magnetic properties of black oxide
sludge increase shaft and bearing wear in pumps causing
them to stick or fail. |
Put
simply: "Powerflushing prolongs heating system life"
For all your plumbing, heating, gas and drainage needs in Edinburgh
and surrounding areas, from repairs to installations, you can
rely on the professionalism and care of Triple Point.
CALL
NOW: 0800 037 6525
|
| [ Scheduled
Work ] [ Maintenance
Contracts ] [ Other
Services ] |
Scheduled
Work